Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST Design Studio Voltage Signal Source

Status
Not open for further replies.
A

ashlar20

Newbie level 2
Joined
Dec 2, 2015
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
17
Hello,

I am currently trying to simulate a full wave bridge rectifier in the design studio portion in CST to use with an antenna. First my professor wants me to simulate the rectifier in CST using the signal voltage source and I want to set the frequency of the source to 2.45 GHz, but I cannot figure out how to change this parameter.

Any help would be appreciated.
 

hi,
personally I have never try it, but I suppose that it can be done using Simulation->Signal.
I have attached an image , Hope that it will help you!
regards! source.png
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top