Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, you can do it utilizing Mosfet as a switch, You didn't provide the power figure of your signal so i am not able to suggest you the exact mosfet model number.
Yes, you can do it utilizing Mosfet as a switch, You didn't provide the power figure of your signal so i am not able to suggest you the exact mosfet model number.
Hi,
I would like to pass/stop 20V signal using 5V control , in cadence like transmission gate . as shown below.
5V control is selectable: it should enable one path at time if we select 5V and other when 0V is applied or any other scheme if suggested i would be thankful.
regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
