Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can polarised electrolytic capacitors be used to make high/low pass filters?

Status
Not open for further replies.
R

Resistanceisfutile

Member level 4
Joined
Aug 22, 2012
Messages
77
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
2,008
I want to make a SIMPLE low pass filter for an audio circuit, something similar to this:
https://en.wikipedia.org/wiki/Low-pass_filter#/media/File:RC_Divider.svg

I have some ceramic caps but they are low capacitance so I have to use high value resistors and then I get no sound (current too low?)

Could I use electrolytic capacitors to make a simple low pass filter?
Would I have to bias the audio signal?
 

An electrolytic capacitor is inaccurate because it has a wide range of tolerance. So if it is rated at 100uF then it could be anywhere from 50uF to 200uF. A polarized capacitor should never have reversed polarity.
You got no sound because the low input resistance of what the high resistance filter is driving created a voltage divider. The RC filter should have a very high load resistance.

Usually an RC lowpass filter uses a high value resistor and low value reasonably accurate small capacitor (5% film) then it is followed by a very high input resistance opamp.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top