camius
Newbie level 3
Hello,
While waiting for a synthesis tool license I am forced to use WINCUPL in order to test an atmel CPLD. Made a program to turn on LEDs with buttons but was not able to load again. Figured out that when I did a JTAG override in ATMELISP, I would no longer be able to access JTAG without a stand alone programmer. My question is, how do I enable JTAG in a .JED file. Below is a snipper of the .jed file generated by WINCUPL.
Using ATMEL ATF1504AS CPLD.
Thank you
While waiting for a synthesis tool license I am forced to use WINCUPL in order to test an atmel CPLD. Made a program to turn on LEDs with buttons but was not able to load again. Figured out that when I did a JTAG override in ATMELISP, I would no longer be able to access JTAG without a stand alone programmer. My question is, how do I enable JTAG in a .JED file. Below is a snipper of the .jed file generated by WINCUPL.
Using ATMEL ATF1504AS CPLD.
Thank you
Code:
NOTE device configuration bits*
NOTE 0 0 0*
L34134 00111111111011010000000111111111*
NOTE Special Purpose Bits (JTAG) *
L34166 1011*
NOTE UES bits*
L34170 1111111111111111*
NOTE Reserved bits *
L34186 000000*
C3734*
0000