chenchen410
Newbie level 2
Hi,
I want to run power analysis in synopsys primetime, and I have generated the netlist and the sdc file of my design as well as the vcd file from modelsim. But when I run the PrimeTime, there’s such error:
Error: Can not find any event in the event file. (PWR-248)
In the generated power report, the power is 0.
So what does this mean? My simulation file vcd should be correct, because in modelsim the simulation result is correct. My simulation is based on the rtl code, not netlist.
Thank you very much.
- - - Updated - - -
The command to read vcd I used is:
I want to run power analysis in synopsys primetime, and I have generated the netlist and the sdc file of my design as well as the vcd file from modelsim. But when I run the PrimeTime, there’s such error:
Error: Can not find any event in the event file. (PWR-248)
In the generated power report, the power is 0.
So what does this mean? My simulation file vcd should be correct, because in modelsim the simulation result is correct. My simulation is based on the rtl code, not netlist.
Thank you very much.
- - - Updated - - -
The command to read vcd I used is:
Code:
read_vcd /prime_time/questa_simulation/simulation/questa/ -rtl -strip_path sim_top/NoCM