Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Poor Covergence in Computing Port Dispersion

Status
Not open for further replies.
K

KawtherHamad

Member level 1
Joined
Feb 15, 2015
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
276
Hello All,

What is the significance of the message Fast sweep setup. proccess hf3d: Poor convergence in computing port dispersion?

Thank you
Kawther
 

KawtherHamad said:
Poor convergence
Click to expand...

Convergence is a concept in simulators. Are you using a simulator? When it evaluates your circuit, it runs the values through calculations, and repeats the process, until it converges on a stable output (for that timeframe). Then the simulator goes on to calculate the next timeframe.

If it cannot reach convergence, then it creates an error.

- - - Updated - - -

'Poor' convergence suggests your circuit (or settings you chose) is causing incorrect results.
 
Thank you Bradthred. Does this affect the result i get, for example, does it affect the S11 result?
 

KawtherHamad said:
Thank you Bradthred. Does this affect the result i get, for example, does it affect the S11 result?
Click to expand...

Perhaps my reply was about a different type of convergence. That kind of error is liable to cause the simulation to halt.

However your convergence problem may be in attempting to calculate S11.

Try starting out with a simpler circuit which does not cause the error. Change a value, or add a component, one at a time, until you have your desired circuit.
 

Hello All,

I have a problem when simulating my structure using HFSS. It keeps giving me the warning : poor convergence in computing port despersion.

When i do simulations, i do not find major effects to the changes i add to antenna structure. Can this be due to the poor convergence in computing port despersion? does it prevent HFSS from finding the correct results? how can i get rid of this problem?


Thank you
Kawther
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top