Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Atmega328P reset Pin stays Lo

Status
Not open for further replies.
D

drumanart

Newbie level 4
Joined
Apr 4, 2008
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,323
Hello.
When powering up my Atmega328P the reset pin (pin 29) is pulled down, so the chip stays in a reste mode.
Strange is that this happens not allways.
I can force the chip, pulling the reset Pin Hi, when connecting 5V to pin 29.

This behavier is with, or without a serial programmer connected to the device (I use the Bootloader)

Martin
 

Do you have the reset pin connected to +5 volts through a 10K pullup resistor ? This is the standard way to handle the reset pin on an ATmega328.

reset.jpg
 
Last edited:

FenTrac said:
Do you have the reset pin connected to +5 volts through a 10K pullup resistor ? This is the standard way to handle the reset pin on an ATmega328.

View attachment 122889
Click to expand...


Yes I have a pullup resistor of 4k7, but thanks to your advice I noticed that on of the pins has been badly connected.

This makes sense

Thread solved thanks Martin
 

check the fuses there are a fuse that if you set/reset the reset function is disable and the pin work as a normal in/out pin.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top