Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] S11 of a EBG msurhoom cell

Status
Not open for further replies.
R

rualex88

Newbie level 4
Joined
Sep 2, 2015
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
63
Hi all ! I am trying to calculate S11 of my mushroom unit cell , i do not want to use the floquet port , I red somwhere that i can use a PEC in the Z + and - direction and in the side walls i can use PMC , with some radiation boundary or PML , but i think that i am doing some mistakes in the setup , some one know if i must use a wave port or a incident plane wave and can describe me how to setup this kind of simulation?

thx

rualex88
 

What software are you using?

rualex88 said:
i do not want to use the floquet port
Click to expand...

Why not?

rualex88 said:
i can use a PEC in the Z + and - direction
Click to expand...

Are the mushrooms in X-Y?

rualex88 said:
some one know if i must use a wave port or a incident plane wave and can describe me how to setup this kind of simulation?
Click to expand...

To simulate at normal incidence, you could just assign a perfect H to one pair of side walls of the unit-cell, perfect Es to the other, and assign a waveport on the face normal to the mushroom surface. Don't forget to de-embed for proper phase information.
 
Hi PlanarMetamaterials , I am using HFSS , I can not use floquet port becouse there is a problem for the S11 , the problem is : if you add a substrate on the cell and you want measure the S11 at the surface of substrate HFSS show you strange results of S11 , I calculated the S11 with matlab using the trasmission line model and there are some big differences , so I wanted to try other ways to calculate the S11 , I solved the problem using a wave port and putting Perfect E along the X walls and Perfect H along the Y walls , I obtain the same results as floquet. Thx for your quickly answer
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top