Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

xbee communication with pic doubts

Status
Not open for further replies.

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
360
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,995
i am having xbee2 module, my aim is to transmit serial data wirelessely. i am using xbee in transparent mode.

i am having a pic micro 18f25k22 that operates in 3.3v . now i am printing a serial message "testing xbee" this is done if connect to hyperteminal i can see this. now i connected the tx terminal of pic to D-IN terminal of xbee, on another side of xbee i recive the data in D-OUT Pin of xbee and convert to rs232 and connected to pc hyperterminal but i cannot able to see the " testing xbee " the hypertimanal is blank with some junk characters no data
my baudrate is 9600
kindly tel me how to proceed is there is any configuration settings for xbee?

kindly help
regards
kalyan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top