Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to do post-layout simulation

Status
Not open for further replies.
I

icfb

Junior Member level 2
Joined
Jun 10, 2004
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
178
after layout, how to do post-layout simualtion with DRACULA?
thanks!
 

Do PRE with DRACULA. Then use simulation tools (hspice, starsim, hsim, nanosim, etc.) to do post-layout simulation.
 

thank you!
but i use spectre of CADENCE, what should i do?
Before doing PRE, must LPE be done?
when i do LPE, i get the SPICE format netlist. how should I use this SPICE format netlist in SPECTRE?
thanks!

Hughes said:
Do PRE with DRACULA. Then use simulation tools (hspice, starsim, hsim, nanosim, etc.) to do post-layout simulation.
Click to expand...
 

Spectre can simulate a SPICE netlist. But I don't know how to view the results.
 

The same as circuit simulation with Spectre.
You need to add some things to the netlist, such as voltage source, and analysis ways.
 

Alos set the KEEP DATA = YES in Drac..
set to smart will NOT work.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top