adnan012
Advanced Member level 1
hi,
I want to set 2 layer PCb substrate in Ads 2009.
Copper
FR4
Copper
What are the proper steps? Vias setup is also required.
To make ground plane and copper areas , i am using polygon which are not reflected back in schematic (layout to schematics). Is there any other way to do the same job?
I want to set 2 layer PCb substrate in Ads 2009.
Copper
FR4
Copper
What are the proper steps? Vias setup is also required.
To make ground plane and copper areas , i am using polygon which are not reflected back in schematic (layout to schematics). Is there any other way to do the same job?