Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Active magnetic loop, how big should it be?

Status
Not open for further replies.
neazoi

neazoi

Advanced Member level 6
Joined
Jan 5, 2008
Messages
4,119
Helped
13
Reputation
26
Reaction score
15
Trophy points
1,318
Location
Greece
Activity points
36,918
Hello I want to build an untuned (broadband) magnetic loop for LF to HF (100KHz-30MHz) reception.
The loop must have the next characteristics:

Frequency of coverage: 100KHz-30MHz
Design:



A preamplifier with about 20db of gain will be used to make it an active loop https://www.g8jnj.net/activeantennas.htm

To be "magnetic" at HF and below, the loop should not be big. But how small can I make the loop, so as not to lose the directivity (nulling) feature at these frequencies and at the same time provide reasonable reception sensitivity (based on my 20db preamplifier)?
 
Last edited:

neazoi said:
Hello I want to build an untuned (broadband) magnetic loop for LF to HF (100KHz-30MHz) reception.
The loop must have the next characteristics:

Frequency of coverage: 100KHz-30MHz
Design: https://i.stack.imgur.com/LgKnc.png
A preamplifier with about 20db of gain will be used to make it an active loop https://www.g8jnj.net/activeantennas.htm

To be "magnetic" at HF and below, the loop should not be big. But how small can I make the loop, so as not to lose the directivity (nulling) feature at these frequencies and at the same time provide reasonable reception sensitivity (based on my 20db preamplifier)?
Click to expand...

Magnetic-loop antennas can have the circumference one lambda or a fraction. Best used at resonance which limits noise bandwidth and increases the low radiation efficiency.
Making the loop one or up to four turns allows to diminish the size. Directivity is affected by loop position above ground.
At short waves using a low-noise preampliier makes no sense due to atmospheric noise. Receiver sensitivity is rather affected by noise bandwidth, therefore use the resonant loop.

Details can be found in "Burger, Dvorsky, Magnetic Loop Antenna" book, available at www.pollabs.com
 

jiripolivka said:
Magnetic-loop antennas can have the circumference one lambda or a fraction.
Click to expand...

To make it a magnetic loop, the circumference should be small compared to the wavelength. I would start with lambda/10 or so at the highest frequency, and see if capacitance values are practical.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top