Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
How to analyse the circuit below when M3 is connected from Vout to Vin ? Will that affect the Vout ? How Vout vs Vin curve looks like ?
M1,M2 and M3 are identical.
As shown won't bias easily for same Vgs and give high gain.
Probably saturated. ( ie. a big non-linear attenuator) since large output switch will saturate input, so all 3 will not be in linear range, unless very low Vgs.
I'm tempted to suggest you perform an AC and Transient analysis at some online simulator; the circuit is quite simple. Anyway, in adding some components close to M3, I would dare to say that could work as an AGC circuit, just a guess
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.