Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Hameg HM205-2 asymmetrica display.....

Status
Not open for further replies.
E

ecca

Newbie level 2
Joined
Aug 22, 2015
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
14
Hi all from a newbie......
I bought a Hameg HM205-2 oscilloscope this morning at a car boot for the princely sum of £3.
It's cleaned up OK and miraculously it all appears to work OK except that the display is asymmetrical, one side different to the other horizontally.
I've downloaded the manual but there's no solution there that I can see.
Any ideas ?
Here's a picture......

11947413_10207873282093149_5281012301777131709_n.jpg

Cheers,
Eric Thacker (UK)
 
Last edited by a moderator:

Your beam starts out fast, but then slows down during its sweep toward the right. This is a fault in the sweep waveform.

The sweep is a sawtooth oscillator. The sweep waveform should be linear. You probably have a component which no longer has linear gain characteristics.

The scope has internal calibration adjustments, for sweep speed, and sweep length. Can you locate these? There is also horizontal position on the front panel. By playing with these various adjustments, it may help you to diagnose the correct section.
 

Thanks for that.
I've located a preset VR3101 on the TB board that I will adjust.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top