Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to Define the transformer Primary & Secondary windings in SIMetrix ?

Status
Not open for further replies.
M

madhu.b

Member level 3
Joined
Sep 25, 2011
Messages
66
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,846
how to Define the transformer Primary & Secondary tuns in SIMetrix ?

Hello,

I am using the center-tapped transformer in SIMetrix simulation tool. The exciting tuns ratio of the transformer are 8:2. The primary tuns I have set to 8 turns according to the ratio.
Now, what value I have to give to the Ratio to primary 1 ? (See in the attachment)
Is the value of 250m or 2 according to ratio?
 

Attachments

  • Transformer Parameters.png
    Transformer Parameters.png
    12.7 KB · Views: 152
Last edited:

I am not familiar with SIMetrix, but I think you should enter .25, because that is the ratio of 8:2.

If you were to enter 2, I believe you would step up the voltage 2x.

Sometimes in a case like this, it's a good idea to run a test simulation on your transformer. Apply a simple sinewave, and watch the output, whether it is stepped up or down.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top