Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

interfacing relay with avr microcontroller in altium

Status
Not open for further replies.

Mohammad Ghorbani

Newbie level 4
Joined
Jul 5, 2015
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
iran
Activity points
42
hi there . is this right interfacing a relay with microcontroller ?


Untitled.png
 

The circuit has the advantage of minimal part count. It's O.K. if the relays will reliably engange with only 4.3V. Otherwise use standard common emitter driver with base resistor and freewheeling diode.
 
use standard common emitter driver with base resistor and freewheeling diode.

I usually put a ceramc capacitor close to the relay coil in order to provide some additional spike suppression.
 
i'm condused . my schematic is this
Untitled.png

but in pcb auto roue it routing different . look at this

Untitled2.png


what is problem ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top