Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

microcontroller input and output voltages

Status
Not open for further replies.
A

Antenna (^.^)

Member level 3
Joined
Jul 6, 2015
Messages
54
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
499
Hi everybody,

I am using ATtiny87 microcontroller, and I need 12 for I/O pins. The pins are digital ports. However I can't find anywhere in the datasheet to tell me what
exactly is the output voltage that is equivalent to 1 (on) and 0 (off). I also can't find the range of acceptable voltages input voltages the microcontroller
accepts (I found the operating voltage but i don't think that is the same thing)! :-?
 

Hello!

I would be surprised that it's not in the documentation, in "electrical characteristics".
You should find the maximal value of a 0 and the minimal value of a 1.

Dora.
 

Antenna (^.^) said:
Hi everybody,

what exactly is the output voltage that is equivalent to 1 (on) and 0 (off). I also can't find the range of acceptable voltages input voltages the microcontroller
accepts (I found the operating voltage but i don't think that is the same thing)! :-?
Click to expand...

see this,
Capture.PNG
refer this link http://www.atmel.com/Images/Atmel-8...ller-tinyAVR-ATtiny87-ATtiny167_datasheet.pdf
Page number for the complete table is 242
 

Hi,

Above you see VOL and VOH,

Now look for VIL and VIH.

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top