Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

IR infrared emitter and reciever

Status
Not open for further replies.
A

abdi110

Member level 3
Joined
Mar 5, 2015
Messages
60
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,728
I am going to design an infrared emitter circuit to detect a shaft position. And when the shaft is in front of the emitter then the reciever doesn't receive any signal and therefore detects that the shaft has reached the position.
I should use the forward bias for the emitter led but what should I do for the reciever part?
 

An IR receiver usually uses a photo-diode or photo-transistor at its input.
A photo-diode that is reverse-biased is fast because the bias reduces its capacitance. Light makes it leak current.
A photo-diode with no bias is a mini solar cell that produces an output when lit.
The collector-base of a photo transistor leaks current when lit and the transistor amplifies it.
 
A typical position sensor light barrier (e.g. in a printer drive) uses a photo transistor with a several kohm pull-up resistor.

The essential point is that you can avoid extraneous light hitting the sensor. In applications where this can't be guaranteed by design, a modulated light barrier should be considered.
 
Modulated light avoid false triggering, you should consider make this general circuit, once it works, then adapt it.
**broken link removed**
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top