Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Video driver / amplifier necessary?

Status
Not open for further replies.

TQFP

Junior Member level 3
Joined
Aug 11, 2007
Messages
30
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Florida
Activity points
1,666
I have a circuit that drives a VGA monitor using a simple 4-bit (per color) resistor DAC. This works well, colors look great, image is stable, etc. However, I also see circuits in datasheets (like the typical use schematic from AD725) or on other boards that use buffer ICs or discrete transistor amp circuits. How do I know if I should be using something similar? Since my circuit is working fine, what would I gain by using something like an AD8073? Here are three examples of circuits that I have seen. Can anyone explain why/when you would use one over the other?

Thanks,
Matthew

rgb_dac.png
Resistor DAC, similar to what I'm using. Works fine.

uvga3.png
Discrete amp

ad8073.png
Using a video IC
 

I think it really depends on what your load is. I thought VGA was 75 ohms, which is why you need a driver. Not sure why your circuit works at all.
 

Very often the video chip just drives current through the 75 ohm resistors in the VGA monitor, its just a relatively high impedance current source.
This works fine if the cable is very short with a low shunt capacitance, as is usually the case.

But if you wanted to send that video down a very long cable, a proper video buffer amplifier with a 75 ohm output impedance would give much better results.
 
  • Like
Reactions: TQFP

    TQFP

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top