Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

is it possible to use MIO pins as Normal IOs in PL section?

Status
Not open for further replies.

Port Map

Advanced Member level 4
Joined
Aug 24, 2013
Messages
118
Helped
15
Reputation
30
Reaction score
14
Trophy points
1,298
Activity points
2,089
Hi, I have a Zynq training board with some peripherals connected to MIO pins.

I want to use some of this peripherals inside PL section. But I cant.
for example I want to use ethernet pins and bring the signal from outside to PL but when I create a UCF and run Map, the MAP fails.

Is it possible to use MIO pins as normal IOs in PL section?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top