Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ground question in powersupply

Status
Not open for further replies.

aliyesami

Full Member level 6
Joined
Jan 7, 2010
Messages
369
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
USA
Activity points
4,190

Attachments

  • meanwell_LDDdriver.jpg
    meanwell_LDDdriver.jpg
    64.4 KB · Views: 51

For -Vin it says, RIGHT THERE ON THE DATA SHEET, , "don't connect to -Vout". I guess that means you shouldn't connect them together. Further, why do you even think you need to "ground the output"? You're driving an LED; connect one side of the LED to +Vout, connect the other side to -Vout. Done.
 

For -Vin it says, RIGHT THERE ON THE DATA SHEET, , "don't connect to -Vout". I guess that means you shouldn't connect them together. Further, why do you even think you need to "ground the output"? You're driving an LED; connect one side of the LED to +Vout, connect the other side to -Vout. Done.

then on pcb layout how will i lay my ground layer? will i have two ground layers ? one for 50V and one for 3.3v and 12v ?
 

Upon closer examination, I realize I have no idea what you are trying do. The LDD700 is a constant- current led driver that you have hooked up to some unidentified device, perhaps a regulator? WHAT IS GOING ON HERE?
 

its a very simple working device. . LDD700H is fed 50v , and the output is driving two LDO's one producing 12v and one producing 3.3v
 

its a very simple working device. . LDD700H is fed 50v , and the output is driving two LDO's one producing 12v and one producing 3.3v

And what is the output LDD700? It's a constant current. I think you want a DC-DC VOLTAGE converter, not an LED driver. Or, better yet, why don't you just use two switching regulators?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top