Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microphone as a blow switch

Status
Not open for further replies.
A

adityabhandari54

Newbie level 5
Joined
Jun 10, 2014
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
67
Hello,
I am designing a circuit which shall turn a device ON or OFF by blowing on it. I have a circuit in the form of a counter where in when a switch is pressed, the count is incremented, and i have the relay connected to the LSB of IC 4017. So each time i press a switch, the LSB turns from 0 to 1 or vice-verse and this signal is given to my relay to turn it ON or OFF. I want to modify this circuit to blow activated in stead of switch, so can a microphone be used

Regards,
Aditya
 

Yes it can be used. All you need is a microphone, couple of transistors, a capacitor and a pot for adjusting dB level. Connect two transistors, say BC547, as a darlington pair, connect a pot of 100k or 500k with vcc to mic, then mic to gnd. Feed the pot output to a ceramic cap of 10nF, then to the darlington pair gate, and feed the emitter to your counter switch. Adjust the pot for your desired noise level.

Google have a lot of reference designs for microphone.
 

Genovator said:
Yes it can be used. All you need is a microphone, couple of transistors, a capacitor and a pot for adjusting dB level. Connect two transistors, say BC547, as a darlington pair, connect a pot of 100k or 500k with vcc to mic, then mic to gnd. Feed the pot output to a ceramic cap of 10nF, then to the darlington pair gate, and feed the emitter to your counter switch. Adjust the pot for your desired noise level.

Google have a lot of reference designs for microphone.
Click to expand...

A 555 can be used, and a common "electret" microphone with 12 V DC bias via a 20 kOhm resistor generates more than 0.5 V pulse if you blow over it. Use a 555 as a monostable multivibrator.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top