Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

designing of Gilber cell mixer circuit

Status
Not open for further replies.

sujata10

Newbie level 4
Joined
May 5, 2015
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
22
Hello everyone,

I have design gilbert cell mixer. I have attached its schematic and simulation result please check if it is correct ??? sir_design.pngsir_design.jpg
 

No, it doesn't work.You have to drive LO and RF ports differentially.But you connected one of them to ground.
 

So how can i do that??

- - - Updated - - -

I think by giving opposite polarity signal on the negative side of LO and RF?? I am completely new in this field please help me.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top