Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
External trigger back panel connection is handy in rack
setups, put the master timebase to it for best jitter and
timing measurement consistency. Or loop your 50-ohm sig
gen source to it as well as the DUT, rather than using a
probe. It's just a resource, there in case you need it.
If two events like pulse of your interest and the pulse causing it are time correlated, the external trigger could be used.
Y input can be your signal and the external trigger could be the pulse initiating the process.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
