Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Calibre LVS issue(gate length property error)

Status
Not open for further replies.

guruprasadds

Newbie level 5
Joined
May 1, 2015
Messages
10
Helped
1
Reputation
2
Reaction score
2
Trophy points
3
Activity points
90
Hi Friends,
Im running calibre for my LVS 28nm digital design, Im getting property errors with mismatch in gate length and with with max 1.56% and .06% difference respectively in layout vs schematic.
Can any one help me to resolve this? im confused about what value and where to set in rule deck.
tapeout is 5 days away so please some one help me.
 

Attachments

  • lvsissue.png
    lvsissue.png
    27.3 KB · Views: 313

im confused about what value and where to set in rule deck.
tapeout is 5 days away so please some one help me.

I don't think you'll get a "go" if you change the rules deck. Better readjust W & L in your schematics!
 

There is a variable in most decks that set the tolerance

---The Default setting for property check is 0%. Users should check with IP/Design providers for proper tolerance.

Do a search for "tolerance" in your rule file and it should tell you how to set the default from 0% to a higher value.
 

Hey Erikl and Dharmaslice,
thanks both of them for the reply. I resolved it. Problem was it was comparing wrt 4th significant digit. You can look in to the error image i have attached.
the digits in source and layout are 3 and 4 respectively.
So i enabled HIGH_RESOLUTION switch in rule deck, enabling ll compares upto significant digit. I think looking into Rule deck n that switch may make u guys understand the issue.

Thanks
Guru
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top