relax79
Newbie
Hello friends, I am open this thread
"https://www.edaboard.com/threads/330076/"
but nobody help me, I have a bus pirate v3.6 but I am noob this type of things, I am the hardware guy. I am examine the MN101EF31G Lsi User Manual (datasheet) and I confused the understanding register table. Some bits are
"reserved = always set 0" I am understand
"don't care = 1 or 0" I am understand
but some are "-" dash mark (symbol) I am not understand.
How do I set these bits.
Other problem is I can not send long address in bus pirate like"0x128" bus pirate convert the "0x28", I know dumping, programming and interfacing (I am not success yet) each type serial port (Sync Serial, I2C, Uart) hard for noobs like me but please somebody show the right path for me at least. Each serial ports have a activation and adjustment registers, if the ports closed, how can I send activation command.Sorry for my poor English, thanks.
"https://www.edaboard.com/threads/330076/"
but nobody help me, I have a bus pirate v3.6 but I am noob this type of things, I am the hardware guy. I am examine the MN101EF31G Lsi User Manual (datasheet) and I confused the understanding register table. Some bits are
"reserved = always set 0" I am understand
"don't care = 1 or 0" I am understand
but some are "-" dash mark (symbol) I am not understand.
How do I set these bits.
Other problem is I can not send long address in bus pirate like"0x128" bus pirate convert the "0x28", I know dumping, programming and interfacing (I am not success yet) each type serial port (Sync Serial, I2C, Uart) hard for noobs like me but please somebody show the right path for me at least. Each serial ports have a activation and adjustment registers, if the ports closed, how can I send activation command.Sorry for my poor English, thanks.
