Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

a few simple questions about monopole antenna

Status
Not open for further replies.

ghasem_008

Full Member level 4
Joined
Feb 9, 2012
Messages
221
Helped
11
Reputation
22
Reaction score
10
Trophy points
1,298
Activity points
2,990
hi.
I'm going to cover a wide frequency range (for example 2-200 MHz) using a monopole antenna.
At first:
I have a few simple questions about monopole antenna.
Does anyone can help me?
Basic questions:
1. Does "monopole antenna length" should be λ/4 only (please answer in both transmitting and receiving mode)?
2. what is mean of narrowband and wideband monopole antenna?
 

1. Any length is ok, both TX and RX as long as it fulfills your needed system functionality. λ/4 is a practical length due to its impedance is reasonable easy to match against common types of TX & RX impedances. Shorter monopole antenna then λ/4 will reduce antenna efficiency and radiation resistance will be lower, causing reflection losses if not compensated for.
Reduced overall antenna efficiency can be compensated with higher TX power level. For RX is it a bit more complicated as added amplification to compensate for reduced input level also adds noise from internals of amplifier which reduces signal noise ratio. Antenna length do also effect radiation pattern, especially when monopole antenna length is longer then λ/4.
2. Can be a lot of reasons. An antenna that must be heavily impedance matched to fit system-impedance do often become narrow in its usable frequency range due to properties of matching elements and for real low radiation impedance do resistive losses in non ideal matching components become an important factor.
 
Supplementing the answer to question 2. An electrical small antenna (l << λ/4) will have small bandwidth by nature (or high losses respectively).
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top