Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Function properties window problem in Cadence 5.033

Status
Not open for further replies.
E

eng

Junior Member level 1
Joined
Mar 10, 2003
Messages
16
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
194
Hi all,
I just installed Cadence 5.033 on my system. In Virtuoso Schematic and Layout Composer when I press "m" or select move function from menu, the function works but I cannot see its properties dialog box where I used to select move properties such as horizontal, vertical, any angle etc. This problem is same for other functions such as copy...
I didn't have this problem in version 4.46.
What kind of settings should I do to bring it back?

Thanks
 

I don't know how to change setting, but if you press F3 this window will pop up.
 

    E

    eng

    Points: 2
    Helpful Answer Positive Rating
I have found how to change setting:
CIW -> Options -> User Preference -> Option Displayed When Command Start (set this option)
 

Some times the windows pop up out of the limit of your display. You can try to continuous open up the Move function windows, then you will see the windows go down each time you press "M' and then just go out of your monitor :)
 

you will probably find out that some setups for 446 and 5x are different. What that means that setups you had in 446 are not loaded or recognized by 5x
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top