Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

-3dB frequency estimation for basic OpAmp configurations

Status
Not open for further replies.
D

dawwwid

Newbie level 2
Joined
Apr 7, 2014
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hi all,

I would like to ask you a basic question, how to estimate -3dB cut-off frequency of basic OpAmp circuits like inverting amplifier, non-inverting amplifier and unity gain amplifier(buffer).

Thank you,
David
 

This has to do with the gain-bandwidth product. It is different for different op amps.

The faster the frequency, the less gain you can get.

The slew rate may also have some influence.

Some devices are known for being faster than others.

You may find the datasheet gives a graph of gain-vs-frequency.

Or, it might be possible to derive a 3dB cutoff frequency by calculating with the gain-bandwidth product. You get max gain at lower frequencies, then there is a frequency where gain starts to drop.
 

The closed loop bandwidth can be estimated based on the OP GBW (gain-bandwidth product) and the circuit feedback factor respectively closed loop gain G. For the standard non-inverting and inverting configurations you get

Non-Inverting: BWcl = GBW/G

Inverting: BWcl = GBW/|G+1|
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top