Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

code C for conncetion of gyrocompas in FPGA

Status
Not open for further replies.
D

didaSET

Newbie level 3
Joined
Feb 24, 2015
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
22
how to add i2c on MicroBlaze EDK

hello
I need your help I want to connect a gyrocompas(HMC5883L) with a microblaze which is done by I2c and as microblaze does not have the bus I2c. I must add it as a peripheral to the microblaze but I do not know how in EDK
regards
 

Re: how to add i2c on MicroBlaze EDK

In case your your gyrocompas(HMC5883L) has a I2C and the microblaze does not, then you need to do a bus protocol conversion. A traditional way to do this is to use a protocol conversion bridge. So if your microblaze is using ABC protocol, then you need to design a ABC-to-I2C bridge and add it to the Microblaze.
 
Re: how to add i2c on MicroBlaze EDK

I'll see it thank you
 

hello
Someone has already work on the code for the conncetion of gyrocompass HMC5883L with MicroBlaze in 3AN FPGA
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top