becko1
Newbie level 3
Hi,
My problem is the following: whenever i program my Basys2 Fpga board with Adept, the 8th led (LD7 - g1) is always turned on, even if the matching switch is set to 0, and if I want to use that Led with my program. It only works fine with the Adept user demo bit file (then I can turn off and on the led with the switch), with the Adept test, it doesn't work either.
Is my device malfunctioning or is there a solution to this? (Other than this, it works fine, if I dont need that led)
My problem is the following: whenever i program my Basys2 Fpga board with Adept, the 8th led (LD7 - g1) is always turned on, even if the matching switch is set to 0, and if I want to use that Led with my program. It only works fine with the Adept user demo bit file (then I can turn off and on the led with the switch), with the Adept test, it doesn't work either.
Is my device malfunctioning or is there a solution to this? (Other than this, it works fine, if I dont need that led)