Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Altium; Internal groud & Power planes diconnecting from nets assigned. Why ??

Status
Not open for further replies.
Z

zothman

Newbie level 3
Joined
Oct 30, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
Brandon, FL
Activity points
17
Can someone help me figure out why Altium disconnects my plane from the net I already assigned it to ??? Specially split planes; I mean that is a pain in the a$$ to redo !

Please help !
Thanks so much.
 

I think that split plane you might be connected to "no net". Same problem facing here.

Solution: Create a fake net(just a single-small wire) in schematic,give a net name. Same net name assign to the split plane.
 

Usually it happen when you break some line belonging to split planes. The plane assume the net of its neighbors planes. Are you sure the lines boundaries of the split plane are not broken?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top