Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to get 1 to 17V out of 5V

Status
Not open for further replies.
P

pkaras

Junior Member level 1
Joined
Aug 5, 2010
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,415
I am looking for a simple solution how to get 1V, 3V, 5V, 7V, 9V, 11V, 13V, 15V and 17V outputs supplying 5V. The idea is to use a microcontroller which would switch between these ranges. Max current will be only 40mA. There is no need in great accuracy - it could be 0.5 or 1.5V when 1V is expected.

I was thinking about using two DC-DC converters, but that would make final solution quite complicated.
 

You can use a single DC/DC boost converter with a digital resistor to adjust the output voltage.
 

Do you know any digital resistors that are rated at 40+mA?
 

Besides a voltage boost function, you also need a means to reduce the voltage which isn't possible in basic boost topology. Considering the low current requirement, a separate linear regulator stage seems more appropriate than a buck/boost topology.

Variable boost converters for low current can be found e.g. in flash/processor programming adaptors like PICkit. They are often using processor generated pwm and voltage control through ADC measurement, minimal hardware effort with a bit of software, if a processor is already in use.
 

shaiko, I have looked at DigiKey before asking. It does not provide a column for Watts. I looked though several datasheets, but they specify mA, not mW. For example: https://ww1.microchip.com/downloads/en/DeviceDoc/22147a.pdf

- - - Updated - - -

FvM, I was considering using two DC-DC converters - one step-up and one step-down. That's why I said it was complicated.
I have also looked for Sepic, which would be a perfect fit in my case, but could not find one that fits my requirements.

I will look at PICkit schematics.
 

SEPIC or transformer flyback are ways to control the output range with a single pwm switch. You need
- a switch transistor
- coupled inductors
- a diode and filter capacitor
- an additional capacitor in case of SEPIC
PWM generation can be done by the processor or a switch-mode controller.
 

FvM, from your answer it looks like an easy job to do, but when I look into SEPIC related literature it is quite complex. I even found one documents where authors admit that: "Unfortunately, the SEPIC topology is difficult to understand".

Could you help me choosing those components you have listed?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top