Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Any one familiar with dso 2150 scope

Status
Not open for further replies.
M

Mr_eng

Newbie level 4
Joined
Aug 31, 2005
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,308
Hi Everyone,

I'm trying to look at a 100mv sine wave with a dc 2v offset, I can't seem to find how to use the vertical position control so I can see my dc off setted waveform.

I remember disconnecting earth and reconnecting to the offset on an analogue scope.

Regards

Alan
 

I'm working with a dc offset on a counter i've built, the setup requires that I adjust the pre-amp so that 2 dc offset signals coinside.
 

Your proposed method may not work if your probe ground is connected to chassis ground (which it probably is). Are you just trying to get the dc levels of the two signals the same? Or both DC and AC? Or what? Maybe you need to do this in two steps: adjust the dc levels and then adjust the low-level AC.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top