Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADC - Voltage measurement on negative voltages

Status
Not open for further replies.
C

casemod

Member level 1
Joined
Sep 21, 2013
Messages
34
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,618
Hi folks,

Im having a problem that I was hoping to get some help with.

I have a 96V solar array, in which the battery is divided in two banks with a center point (+48,0,-48)

I need to measure when an imbalance has occurred and for that I need to measure the individual banks. My CPU ground is connected to the 0V supply. I am not sure how to measure the bottom bank as the voltage is negative in respect to the CPU GND.

Note: Both banks need to be measured at the same time, trough a simultaneous sampling ADC, so that rules out most external SPI ADC's.

Any suggestions on this?

Many thanks
 

Are I being too simplistic?
After voltage divider, connect to comparator [dual voltage], voltage limiter, then offset, and finally feed to ADC
 

On the chance this might help...

By making the right adjustment to a resistive divider, you shift the negative signal into the positive region.



Ground reference is not shown, but you get the idea.
 

Another option is supply both +Vref and -Vref of A/D converter with external voltages taken from +48v/-48v battery bank ( e.g. -5v/+5v ), so that can determine precisely the drift from GND, which is the half of full scale references of the analog to digital converter.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top