Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need Help for CS5460A ADC

Status
Not open for further replies.
J

jignesh doshi

Full Member level 2
Joined
Aug 11, 2011
Messages
131
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
2,112
hello friends,

I need some data for CS5460A ADC.

That is how to communicate this ADC with microcontroller.

in its datasheet i am not clear about communication part.

so please if you any one has data then please post it.
 

The device uses an industry standard SPI interface, it's usage is described in datasheet chapters 4. SERIAL PORT OVERVIEW and 5. REGISTER DESCRIPTIONS. There are also code examples at Codeforge.
 

Thanks FvM...
in chapter 4 they described over serial port overview but in that how IC works that they didn't describe.
how can i fatch data from IC that i can't understand from datasheet?
what i have to send sequence to IC for start the communication?
 

CS5460A isn't an ADC, it's a complete single phase energy measurement system, measuring voltage and current and calculating RMS, power and energy quantities.

Basic device operation, registers and how to access it through I2C protocol is described in the datasheet, in so far I don't know what your actual problem is. Besides Cyrrus support, you'll also find CS5460 related software application form other sources, e.g. ww1.microchip.com/downloads/en/AppNotes/00220a.pdf
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top