Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

BNC Connector Drawing for PCB Mounting

Status
Not open for further replies.

subhren36

Newbie level 1
Joined
Apr 1, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,286
I am looking for the CAD drawing for Right Angle BNC Connector 1310709-1 (B35N04J999X) from MACOM.

Appreciate your support.

Subhren36
 

Can't you get the dimensions from MACOM themselves? (whoever they are?)

Googling shows that B35N04J999X is obsolete with most suppliers, however it's a right angled BNC connector so any other of the same type should suffice.
In fact - your not designing this into a new board are you? not a good idea if it's obsolete.
 

The BNC connector is historically one of the most obsolete connectors. I have not seen a good design of it with a PCB mounting
I would prefer a SMA or another miniature connector adapter for PCB mounting, then use a transition to BNC if you like it so much.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top