Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Using ADS , how to find the Band Width of Amplifier Using Predefined BW function

Status
Not open for further replies.

narayani

Advanced Member level 4
Joined
Aug 15, 2014
Messages
119
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,298
Activity points
2,248
Using Agilent Advanced Design System (ADS), How to find the Band Width (BW) of the Amplifier Using Predefined Function.
 

The data display function for bandwidth calculation is discussed here:
http://www.keysight.com/owc_discussions/thread.jspa?messageID=66959��
As you said link, I have gone through that link. They have given many following equations to find the Band Width.

1) bandwidth_func(db(s11),1)
2) bandwidth_funct(dbzin(s11)),1)
3) fc= center_freq(db(s21),0.0000000001)
I messed with the above equations. Which one I have to use. Which one will give the correct bandwidth measurement of the Amplifier.
Is there any other equation to accurate measurement of Band Width in ADS.
 

Which one will give the correct bandwidth measurement of the Amplifier.

These are just examples that show how to use the bandwidth function. It depends how you define bandwith for your amplifier (which parameter to evaluate and how much reduction from the peak value you accept).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top