Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

inverting output of opamp to MCU adc in differntial mode

Status
Not open for further replies.
I

israel_Y

Member level 1
Joined
Feb 8, 2010
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
The Netherlands
Activity points
1,534
Hello,

can i connect an inverted opamp output (0 to -3.3V output) to ADC of microcontroller (stm32) configured in differential mode. From The MCU datashet it says [In differential input mode, the analog voltage to be converted for channel “i” is the difference between the external voltage ADC_INi (positive input) and ADC_INi+1 (negative input).]

So i would be connecting gnd/Vcm=0 of opamp to ADC_INi and the negative opamp output to ADC_INi+1. will this work.

Thank you in advance for your time and answers.
 

Dear israel_Y,

The easiest way to do it is using another Opamp and inverting it again, I draw it for you in the attached file, check please and tell me if that is helpful for you.

Have a nice day,

Best regards,
Juan
 

Attachments

  • TO_ADC.JPG
    TO_ADC.JPG
    9.1 KB · Views: 54

Hi Juan_zo,

Thank you for your answer. but i am avoiding adding any opamp or ADC buffer.. i was looking a way around simply
 

Dear israel_Y,

I was thinking in your question and I thought in a pasive adder, If you connect a resistor to +3V and you signal source give voltage values between -3 to 0V, then, in resistors' midle point, you will have values from 0 to +1.5V.
I hope it cal help you.

Have a nice day,

Best regards,
Juan
 

Attachments

  • 0_3V.JPG
    0_3V.JPG
    8.5 KB · Views: 57
Dear juan,

Thank u so much. is the drawing at the positive input of the opamp?? (or could u draw the circuit with the opamp)? have u simulated the circuit?

Thank you
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top