Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think its to stop the neutral line in floating too far from earth potential. If the output of the inverter is from a transformer, then if a fault occurred and the live output got shorted to earth, the neutral wire would then become live, which can damage equipment.With a clamped neutral the secondary would see a short circuit and pop its trip.
Frank
I'm sorry, I don't basically understand what is "clamped neutral".
If you have or find any documents that explain NPC the better way, Please suggest me :sad:
Hi FvM,
Thank you, I found this image the other day, but I have hard time correlating the term NPC with the circuit above. Please help me figure that.
I posted the schematic to clarify what NPC basically is, didn't attempt to explain the operation principle in detail. There's quite a lot of technical articles available on the internet.
The essential point is that the AC output is connected to NP in leg state 1, through diodes and switches. You should be able to verify this by tracing the current pathes in the schematic.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.