Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I need help in designing a better circuit to control the SSR. The circuit that I have now to control the SSR will not work. I am open to any suggestion to improve my circuitry.
If increasing the cost marginally will not break the bank, I would suggest designing this around an 8-pin AVR micro-controller with at least one analog input and driving an off-the-shelf SSR with 3-32VDC input, switching 220VAC. Off-the-shelf SSRs are available in various output amperage ratings.
- - - Updated - - -
A micro-controller based design will in addition be deterministic, will allow the use of PID routines to control your heater and be easily re-programmable for various models of RTD.
- - - Updated - - -
Sorry about the last circuit diagram - it is erroneous on account of my reading the wrong datasheet. Here is a corrected cct diag...
That's definitely a poor and probably useless temperature control circuit. The tiny processor solution (could be also a small PIC of course) would achieve lowest overall part count, but unfortunately require programming.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.