Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] lag in Altium with Analyzing...

Status
Not open for further replies.
A

asadi.siyavash

Member level 4
Joined
Feb 14, 2013
Messages
68
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Activity points
1,769
Hi, when I moved component in my PCB, after it Altium Start Analyzing even I moved it just 1 mil in free positions. when it start Analyzing I can't do anything until its finishing. I don't have this problem before and I don't know which parameter caused this problem.
what I did for solved this problem:
1. delete all polygon
2. disable all ONLINE DRC
but my problem doesn't solved,

any help would be greatly appreciated.
Analyzing.png
 

Hii,

Did you change any setting in Tools>>Preferences? Make it default(left side down) and try once.
 

My problem Solved :D
Because my board is high density I have to hidden dense nets like VCC and GND.
I hope it help someone.
 

I notice in your screenshot that you're using true type fonts for your component overlays. If you then move such components, it takes a lot of time to render them. Switch the font back to the default "blocky" font and keep font tuning after all components are placed.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top