Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Oscillator problem in flash programming AT89c5131 via flip ?

Status
Not open for further replies.

falcon026

Newbie level 6
Joined
Dec 22, 2014
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
99
my AT89c5131 is being properly detected by FLIP via usb , after applying hardware conditions via board ... but this is only when 8Mhz oscillator is used in the circuit

when i replace 8Mhz by 11.0592Mhz , the microcontroller is not detected after applying hardware conditions.

whenever i need my board to be detected i have to insert 8Mhz, and then after programming flash, if i replace oscillator with 11.0592Mhz then it works fine n according to 11.592Mhz.

The problem is in detection when oscillator is not 8Mhz ... so what to do ?
 

thanks ud23 for ur reply,
actually i have 2 issues, one is that the circuit board (having AT89C5131) is detected by flip software via usb only if i use 8Mhz oscillator . why is it so ?

2nd issue is that if i have to use 8Mhz then how to deal with baud rate? because at 8Mhz baud rate error percentage is quite high. i m using mode1 (8 bit-uart with variable baud rate).
 

it is the issue of flip software as it worked on 16Mhz , and it uses 3 oscilator options for burning i.e. 8,16,32 ....
thats y it was not working on other oscilators. . btw thank ud23 :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top