vaibhavpawar
Junior Member level 1
I have made following circuit, in which I have connected isolator and LM 317.
Opto-isolator is connected between Controller I/O pin and LM317 output. Will this circuit work, especially I am confused about the grounding scheme..when transistor conducts, will this circuit pull down one end of load to Gnd ( since transistor conducts when I/O pin is gnd ).
Is this feasible design to implement?
Thanks in advance.
Opto-isolator is connected between Controller I/O pin and LM317 output. Will this circuit work, especially I am confused about the grounding scheme..when transistor conducts, will this circuit pull down one end of load to Gnd ( since transistor conducts when I/O pin is gnd ).
Is this feasible design to implement?
Thanks in advance.