blazerguns
Newbie level 1
Hi All,
I am working with Ubicom IP3023 and have a work with SPI interface. The SDK has IpSPI which seem to have SPI driver which works using bit banging. While this works its usually very slow. I prefer the SPI uses peripheral hardware for SPI instead of bit banging. From my SDK I noticed that IP2K series used peripheral hardware and for some reason it is disabled or removed in IP3K. Can any one tell me if I can modify to use peripheral hardware for IP3K? I am quite new to this board and I would much appreciate if someone can share ipSPI from IP2K SDK for a reference point to start doing the same for IP3K. If its not possible can someone point out where in the Ubicom document does it state that hardware route is not possible?
Regards,
Chandy
I am working with Ubicom IP3023 and have a work with SPI interface. The SDK has IpSPI which seem to have SPI driver which works using bit banging. While this works its usually very slow. I prefer the SPI uses peripheral hardware for SPI instead of bit banging. From my SDK I noticed that IP2K series used peripheral hardware and for some reason it is disabled or removed in IP3K. Can any one tell me if I can modify to use peripheral hardware for IP3K? I am quite new to this board and I would much appreciate if someone can share ipSPI from IP2K SDK for a reference point to start doing the same for IP3K. If its not possible can someone point out where in the Ubicom document does it state that hardware route is not possible?
Regards,
Chandy