Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

duplicating vias wiyh same net name.

Status
Not open for further replies.
S

swap7etc

Newbie level 4
Joined
Jul 2, 2014
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
39
I am using a 2 layer pcb board,after having a copper pour on both the layers i need to add GND vias on the board.when i try to copy and paste the existing GND via it does not get automatically connected to GND but shows no net name,so if i need to have around 200 via then each tym after pasting it i need to assign the net name as GND to it.Is there any other way to do this as its time consuming n there are chances to miss out some.

waiting for reply......
 

Which software are you using?

If allegro means just click copy icon go to option tab in that there is a option "Retain net of vias" select it and paste the vias where ever you required the same net will maintain.
 
vigneshg05 said:
Which software are you using?

If allegro means just click copy icon go to option tab in that there is a option "Retain net of vias" select it and paste the vias where ever you required the same net will maintain.
Click to expand...

i am using altium in which after pressing 'ea' we get paste array in which there is an option to retain net name but that goes only for one time,again if i paste it then it is the via with no net name.
 

Make sure you have the polygon poured on the board and that you have a net assigned to it (double click the polygon and select a net in the "Connect to Net" drop down box. If you now place a via on the polygon pour it should automatically be connected to that net.
 

There, I knew it wouldn't be long before someone that knew what they are talking about came along :)
 

ArticCynda said:
Make sure you have the polygon poured on the board and that you have a net assigned to it (double click the polygon and select a net in the "Connect to Net" drop down box. If you now place a via on the polygon pour it should automatically be connected to that net.
Click to expand...

I already have a polygon pour which is connected to GND on both the layers i.e. top and bottom layer and later on i need to add via on it......
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top