Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] how to reduce noise in matlab

Status
Not open for further replies.
M

meliasamad

Newbie level 4
Joined
Dec 10, 2014
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
41
hi,

i want to eliminate noise at certain frequency in matlab. anyone can help me??
 

Attachments

  • figure1.jpg
    figure1.jpg
    52.4 KB · Views: 119

Obviously it's not Matlab's fault but the programmer.

What you see is the intermodulation of carrier due to aliasing with another 1 rad/s source. The simple solution cancels the interfering signal.

Let me put on my gold tetrahedral hat for mind reading....


Perhaps the method of detecting the input needs an AC signal cancellation circuit or a higher output level from the BODE calculations.

When Aliasing occurs in amplitutude , it is a MIXING effect due to non-linearities or intentional mixing from an amplitude detector.

Full disclosure of the design or block diagram will get you a better answer,.
 

hi..
i want to eliminate noise at 0.5 rad/s using low pass filter but i dont how to code it because this system is a state space matrix..

sorry i'm newbie in MATLAB.. thanks in advanced.
 


Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top