Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with ahdl Lib Op Amp

Status
Not open for further replies.
B

BKI

Member level 1
Joined
Jul 23, 2014
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
264
Hi,

i have a problem with the op amp in the ahdlLib in Cadence.
I connected it as voltage follower with sinusoidal Vin+ (Amplitude 2.5V, f=10k), Vdd=5V.

I set the following parameters for the opamp:
gain=10000
frequ_unitygain=100M
rin=10M
vin_offset=0
ibias=0 (input current)
slew_rate=10M
rout=50
vsoft=4.9
iin_max=10m (maximum output current)

What i receive is a sinusoidal output signal with amplitude of around 1V. Why is the output amplitude much lower?
 

What load do you have? It may be a loading effect since you have a considerable resistance of 50 Ohms at the output.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top