Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Regarding scalable process in Tanner tools

Status
Not open for further replies.
H

hobbyiclearner

Full Member level 2
Joined
Oct 27, 2014
Messages
142
Helped
2
Reputation
4
Reaction score
2
Trophy points
18
Activity points
1,296
Hello,

I am on hunt for Tanner PDKS. Hence I am bombarding the forum with these questions. In the tanner installation, there is MOSIS scalable HP 500nm process given. Since it is a scalable process, can I change 500nm to something like 350 nm and expect it to work, ie will it remain scalable process for HP. Also, will RC extraction take place.

Thanks,
Hobbyiclearner
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top