Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

problem in stabilizer design

Status
Not open for further replies.

Amin Khorsandi

Member level 2
Joined
Oct 12, 2013
Messages
45
Helped
5
Reputation
10
Reaction score
5
Trophy points
8
Activity points
293
hi
we've designed a stabilizer for industrial purposes. the design details are these:
the output voltage is 220V 50Hz. a microcontroller generates a sine wave. the sine wave applied to an op-amp amplifier and then a push pull amplifier. there is a feedback from the output of push pull to the input of the op-amp.
the output of the push pull is connected to a transformer. the output appears on the output of transformer.
everything works well. the sine wave generates and can also supply loads. but the problem is with loads which have capacitance effect. this causes the output to phase shift of output voltage.
I don't know how to fix it. probably I have to change my feedback way or change the signal generation by a pll.
please give me a solution
thanks
 

Hi,

the phase shift should be small. I assume <10 degree.
What is the problem? As long as you don´t use it for syncing purpose.
Voltage may also change. The maximum i expect when inductance of transformer and load capacitance generate a resonancee.

What power is it?

Klaus
 

I used this to create a 3phase stabilizer. the problem occurs when a capacitance load connected to a phase
now the phase between them is not 120 degrees.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top